Electrical lifts
The FIRST line offers an entirely new generation of electric elevators, tailored to the state-of-the-art construction technology, with the following advantages:
- The whole elevator equipment is located in the shaft, under the ceiling and it is not necessary to build an additional machine room or to provide deep bottoms and high ceilings. This allows extensive application of these lifts, including installation in extraordinary and private cases where a 1500 mm bottom can not be dug.
- The drive is gearless, with a synchronous, extremely economical engine and polyurethane belts. Belts and washers have more than 40 million life cycles and practically do not wear out. The rubbing washers have a diameter of only 86 mm to 114 mm, which provides energy savings. The belts do not need lubrication, which makes their usage energy-efficient and in addition, environmentally friendly.
- Wide load range from 320 to 4000 kg and easy service. Lifts up to 1000 kg. including are with one-sided suspension of the equipment, for which only one supporting wall is required. Above this weight, the lifts can be executed according to the requirements of the project.
- All safety distances, which the lifts must meet in order to comply with the applicable standards, are achieved with additional safety and safe operation systems.
Model „German”
Passenger lifts without machine room with standard suspension. Load capacity from 320 to 600 kg and speed 1 m/sec. Drive via frequency controlled electric gearbox. The lifting mechanism is located at the top of the shaft and the control is at the last stop.
Specification
Download
Model „Genesis EnEf”
Gearless elevators with belt suspension that fill the shaft at maximum. Load capacity 320 to 600 kg. Speed up to 2 m / sec, bottom 800 mm and ceiling 3400 mm.
Specification
Download
Model „Genesis 21”
Elevators with standard suspension, with lifting capacity from 600 to 1000 kg, mostly for wide and shallow shafts. This type of lifts require a bottom under the first stop 500 mm and a ceiling above the last – 3300 mm at a speed of 1 m/sec. At a speed of 1.6 m/sec, a bottom of 1150 mm and a ceiling of 3400 mm.
Specification
Download
Model „Genesis 22”
Elevators with lifting capacity from 1000 to 2000 kg with a minimum bottom under the first stop 1000 mm and a ceiling above the last – 3300 mm at a speed of 1 m/sec. At a speed of 1.6 m/sec, a bottom of 1150 mm and a ceiling of 3400 mm.
Specification
Download
Model „Genesis 41”
Elevators with a carrying capacity from 2500 to 4000 kg, with a minimum bottom under the first stop of 1000 mm and a ceiling of at least 3600 mm. This type of lifts are suitable for both freight and automotive, due to the large dimensions of the cabins and shafts respectively.
Specification
Download